Getting started with Arduino can feel quite overwhelming at first because you're faced with the decision of what board to buy ...

The built-in function analogRead() can be used to read any of the analog pins on the Arduino. However, that method blocks while waiting for the Analog-to-Digital Converter (ADC) to read the analog ...

[4X 98] Output H Phase [10 01] Ack Command/Response Data format unknown [4X 9B] Output Video Phase [10 01] Ack Command/Response Data format unknown [4X A0] Audio Input Level [10 01] Ack ...

Designed by Cirket open-source hardware in China, the ESP32-DIV V1 is a handheld wireless pentesting and experimentation tool ...

Here we describe an electronic system that uses a dedicated water-level sensor to switch off the pump motor as soon as the ...

S, a low-power SoM, which is based on the Rockchip RV1126B (commercial) or RV1126BJ (industrial) SoC. Designed ...

Before the Raspberry Pi came out, one cheap and easy way to get GPIO on a computer with a real operating system was to ...

Here’s a fun build from [RootSaid] that is suitable for people just getting started with microcontrollers and robotics — an Arduino-controlled two-wheeled robot. The video assumes you already have one ...

Abstract: In this paper, we focus on a dimmable visible light communication (VLC) system using PIN photodiodes. In such a system, the main distortion is caused by additive Gaussian noise, however, ...

Kirschner wires, or K-wires, are used to hold and stabilize broken bones. It is important to keep the K-wire site clean and dry to prevent infection. Most K-wires are removed after the bone has healed ...